Results 1 to 1 of 1
  1. 05-17-2023, 06:47 PM #1
    abyrd
    abyrd is offline
    Member
    Join Date
    Jun 2013
    Location
    Oakdale LA.
    Posts
    34

    2012 20xs elite trim

    My boat trim started working by itself going down. When I disconnect the 3 prong wiring harness that runs the front and the trim on the steering wheel trim. The trim will quit. However the trim on the motor and throttle still works properly. So I’m pretty certain it’s not the relay switch on the motor.
    I plugged the three prong plug back up to check the switches. Disconnected them one at a time and trim motor still ran. So it’s not the switches. Is there any other relay switches between those two that might be bad? If so where would it be?
    thanks for any help.
    Last edited by abyrd; 05-18-2023 at 09:41 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »