Can the VesselView Mobile App actually “Block” an error code to stop the alarm beeping?
Picked up my 3rd Optimax - this time a 2008 115 with 200 hrs on it. Checked out and ran fine during test run for 15+ mins and then started throwing the 4 beeps at me, checked water in fuel good & drained VST. Oil tank over half full. Does need a new impeller probably soon but no overheating codes & peeing good.
Installed VesselView Mobile and I’m getting both the oil level/sensor codes - don’t care to replace the whole tank yet I keep a good eye on my oil levels.
Does the “block” function on VesselView actually stop the beeping or do I need to resort to jumping the oil sensor wires?
can’t seem to find any clarity of that online. Thank you!