Guys Running Both AT1 and Garmin LVS32 interference question?

[shooter66]

I have both AT and LS on the trolling motor (AT forward on the barrel and LS in perspective on the shaft). I have a bow interference that goes across the AT screen when the LS in on. Is there a way to clear this up? I also run a 3n1 on the rear and a DI Skimmer on the bottom of the trolling motor....so you know the setup.

[NoCAL]

Anytime you have multiple transducers broadcasting at the same or similar frequencies, the potential exists for them to interfere ie, one picks up and displays the broadcast of the other. Not much you can do other than shut down transducers of the same frequency. It’s not what you want to hear but that’s physics.

[MBDiagMan]

And there’s no repealing any of the laws of physics.

[shooter66]

I fully understand all of that. Was hoping someone else has seen this and if they found a work around besides turning off a unit.

[haus9393]

I had a AT 1 and a lvs 32 during the entire 2022 year and it worked fine no issues. This year I have AT 1 and LVS34 and no issues with cross talk or interference and I’ve used this setup 2 times on the water this year.

by the way I do have the AT pulse that shoots out but I just block that out in my mind. It’s not caused by my lvs transducer though. Garmin screen is clean no pulses.