Can I resetting calibration to make sure it is right? I had some warranty work done on new ipilot link. Service center tech says to pair and calibrate but when I go to the remote systems tab it allows me to pair but no option for calibrating. I’m thinking I no longer have this option since it was done once on install? Thanks
2018 Phoenix 920 Pro XP
Under System, it’s below Boat Scale.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
I know but it does not show up. Is this because it is a one time thing?Originally Posted by CatFan
2018 Phoenix 920 Pro XP
Nope its because your heading sensor is not paired or not powered up or not working
if it doesn't see the sensor it doesn't offer the option
"The handicapped angler"
thank you Roy! Helps if one verifies pairing of heading sensor
2018 Phoenix 920 Pro XP
If they replaced the I-pilot link controller the you will have to apir the sensor and the control and it should give you the cal option. If they just updested the software then you should not have to recal.
Check it out.
Reply With Quote