-
SeaArk 22/72 trolling motor wiring
I have a 22/72 SeaArk that I need to replace the trolling motor wiring in. It appears that they are ran on the inside of the wall before they were welded in. Does anyone have any experience with replacement. Not sure if I have to cut the wall and patch back or exactly what to do. Any advice would be very much appreciated. I am replacing the wire due to it is currently #8 and it has been hot.
-
I would think you could tie on to the existing wire and pull the new right in. Have not tried it on a sea ark, but should be able to be done without cutting holes in the boat.
-
Thanks Alan, not exactly sure what has it wedged, I think it is the live well pump hose but not 100% sure.
-
You could also pull the throttle assembly loose to see if something in there is binding it up, maybe zip tied in there somewhere. Good luck.