Gas tank / Gas Demand Valve question

[FlFedAngler]

This is the tube going down in to my tank. The Gas Demand Valve plugs into this. Is there suppose to be any kind of gasket or o-ring in the flat round area before the valve goes in?

[FlFedAngler]

Just so you guys with RT's know. If you take off the Gas Demand Valve there is an O-ring where I show in the photo below. That was my problem. It was sucking air and not allowing gas flow. When I took off the ring it fell apart. Best 29 cents I ever spent. If you have an older RT might think about replacing it before you get stranded. Mine is a 2015.
GAS TANK.jpg

[Panama]

Would you share the part number and source or how I can order one for a spare or I might just go ahead and change it. Where did you order/buy it? Good info. Thanks for the post.

[FlFedAngler]

Would you share the part number and source or how I can order one for a spare or I might just go ahead and change it. Where did you order/buy it? Good info. Thanks for the post.

If you're talking about the Gas Demand Valve, I got it from Back to Boating. 99IF99IFDV00-1 Integrated Fuel Demand Valve
If you're talking about the o-ring, I just took the part to a local business and they gave me some.

[Panama]

I was talking about the o-ring so I could get a couple of spares without pulling my existing one out... thanks.

[jml]

I bought and carry a spare gas valve.

[FlFedAngler]

I was talking about the o-ring so I could get a couple of spares without pulling my existing one out... thanks.

I will measure my spare o-ring with my micrometer and let you know.