Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
Yes sir and on files page it prompts me to download this new update. I’ll try a different card
2018 Phoenix 920 Pro XP
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
2018 Phoenix 920 Pro XP
I have had 2 occasions where I needed to reformat a micro SD to get an update to work properly. They were new at the time . I used long(full) format to ensure everything was redone and check for bad spots.. The 2 cards have not been an issue since.(San Disk Ultra 32 gig)
Last edited by bobcoy; 01-31-2023 at 02:07 PM.
Tell me where has a slow movin' once quick draw outlaw got to go
Hey Wayne or anyone else that might know.
Something I just thought of. The LiveScope update, this one or any other, is to the LiveScope. Correct, not to the head unit?
There is no need (possibly no way) to update each unit.
When I did the 1.170 update, I installed on the main bow unit only. All seems to work.
Correct ?
I'm assuming you are referring to Mega Live as there is no Humminbird product called LiveScope... That's a Garmin product.
You install the Mega Live update through a head unit which has the latest update but it installs the 1.200 update to the Mega Live itself. You only need to do it once.
---> Regards, Steve Yarbrough (AKA: SLYDoggieTN on YouTube)
- Apex 19/16/13, Mega 360, and Mega Live
- Minn Kota Ulterra Quest Trolling Motor
- (2) Cannon Optimum Bluetooth Downriggers
- Impulse Lithium Batteries... 36V 60AH for Trolling Motor, (2) 12V 120AH for Cranking & Electronics, 12V 60AH for Downriggers
2018 Phoenix 920 Pro XP
I had PT this morning and my fingers don't work. Apparently, my head don't either.
Yes, Mega Live, not LiveScope.
Senility ain't good.
I always have trouble if I do the quick format, try doing the long format, it has worked for me.
@Wayne- I am running Garmin LS, however I have 2 birds ( 1- Mega 360, 1- console- SI).
Can I just apply 2.80 or do I have to apply 1.20 as well?
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
I just finished updating my 3 Helix units and then did the Mega live update. Install went flawlessly. If you have Helix units, probably better to update them first with the Helix update, then do the Mega Live. I definitely can tell they fixed a bug I called to their attention after the last version. Fixed the Mega360 on sharing units stuck in standby screen after the M360 host unit had been in standby. It's good to see that.
2020 Caymas CX20 Pro, Mercury Pro XS 250 4 stroke, SN 2B735045
Helix 15 msi G4N, Helix 12 msi G3N, Helix 12 mdi G4N, Solix 12 G1
Mega 360, Mega Live w/ Targetlock, 8' Raptors,
Minkota Ultrex 112 w/Ipilot Link, (2) 5 Port Switches
Anyone been on the water with the live and headunit updates yet to see if there's an improvement in image?
2018 Phoenix 920 Pro XP
Wayne, need help. In my Helix9msi+ have 2.660 software and 1.031 base map. 2.800 firmware not working, tried on 7 different sd cards- max 32GB- same result. Do I need 2.760 upload before 2.800?
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
Hi all, bringing this thread back from the dead. Has anyone seen a difference with v1.2 compared to v1.17?
I occasionally experience my head unit (Helix 10 MDI+ G4N on v2.750) freezing while using Mega Live (networked off of Humminbird Ethernet Switch) and am only able to hard restart by pulling the power. If anyone has the same issue, has the upgrade fixed it? I'm not sure I want to go to the work of updating my head units and the transducer firmware if not.