Can i connect my SV93 to my 2013 Yamaha 175HPDI to see my engine info?
Can i connect my SV93 to my 2013 Yamaha 175HPDI to see my engine info?
Yes, via NEMA network. I’m in the process of switching from Lowrance to Garmin so haven’t had a chance to check it out yet to see what data you can get.
I have it hooked up on my F200. I think just speed and RPM's maybe something else I can't remember for sure.
You will need a NEMA to Yamaha interface cable if you don't already have one (~$100 on Amazon). Speed is from GPS - on my 08 HPDI, I get RPM's, hours, engine temp, oil pressure, voltage, and I am sure a few others, but those are most useful to me.
Where are the hours located?.....I don't seem to get that
IMG_7555.jpeg
You have to add the hours display to one of your chart / sonar overlays. You can create an Engine Numbers display and see them all in one place if desired.
NMEA 2000 Engine display options:
Hours
RPM
Alternator voltage
Temp
Fuel pressure*
Fuel rate*
Oil Pressure*
water pressure*
trim**
* all require separate sensor
** requires analog trim gauge to be disconnected you can not use both.
Last edited by jpt7779; 02-06-2023 at 06:03 PM.
JT
2014 Ranger Z521C / Yamaha VMAX SHO 250 / IONIC Batteries
Garmin 57” Force TM, ECHOMAP Ultra 106sv’s, LVS34
Very nice--thanks
I realize this thread is a couple of month old. But I repowered with a 2023 Yamaha 200 SHO and I have brand new Garmin 93SV units. I keep reading all i need is the NMEA cable to run from Yamaha to the Garmin. I see her that jtp7779 states I'll need separate sensors for the fuel, oil, and water pressure. I assume I get these from Yamaha? Thanks for the help.