With the engine up and sitting on the tilt stop lever, should you be able to fully retract the trim cylinder rods while holding down the trim switch?
With the engine up and sitting on the tilt stop lever, should you be able to fully retract the trim cylinder rods while holding down the trim switch?
Ranger 2002 175 DVS F115 Yamaha
Ulterra SI, Helix 9 MSI G3 on bow and console
2007 2500 6.7 Diesel Ram 2015 Crusader 294RLT
fish DeGray lake in April & October
I can on my 01 Vmax Hpdi 150
Yes. By design. So that motors moored/stored in water can retract the pistons for better protection.
thanks for the response. I never paid much attention to trim cylinders operation. I just rebuilt my tilt and trim cylinders due to a trim cap seeping and power bled the assembly about 4 times and the trim cylinders won't retract. Ii hear what sounds like cavitation when I try. the Tilt cylinder works normally and smoothly. trim cylinders will retract slowly when pushed by the tilt cylinder.
Ranger 2002 175 DVS F115 Yamaha
Ulterra SI, Helix 9 MSI G3 on bow and console
2007 2500 6.7 Diesel Ram 2015 Crusader 294RLT
fish DeGray lake in April & October