Dual mount console shroud

[Phoenix Jim]

Anyone know what these cost for 2018 920? Apparently mine is cracked on the inside according to my graph installer/friend. I plan on calling Phoenix this week. Thanks

[Phoenix Ed]

I think they should cover it! Good luck.

[haus9393]

Probably about $300 but honestly they will probably just send you a new one free.

[jotahech371]

I had the same thing and emailed him Monday. Tim sent one out and will be here today. Awesome as usual. Johnny

[parkj5]

I would love to trade my dual mount for a single mount for my 2021 920 Elite. I’ll never run dual graphs at console.

[Phoenix Jim]

I had the same thing and emailed him Monday. Tim sent one out and will be here today. Awesome as usual. Johnny

well I had to pay for mine $300. I dealt with Jason. I asked if there were problems with them cracking and he said no. I don’t even run big water

[haus9393]

well I had to pay for mine $300. I dealt with Jason. I asked if there were problems with them cracking and he said no. I don’t even run big water

Lol yea right. It’s a major issue. Everyone and their brother with a Phoenix has been through a dash shroud.

[krindgen]

Wish I knew about that when I ordered. IMO that is the only/best way to mount console graphs.

[Meleagris1]

I dealt with these plastic shrouds on my Skeeter I had before my Phoenix - if you add additional screws right off the bat that will stop the shroud from moving and the movement is what really gets the shroud cracking around the screws. I also put a plate under the dual dash ledge which stops most of the movement/flex there. Setup this way they can take a beating and be fine. I'm on my original console shroud and no issues. On the bow I upgraded to the fiberglass which is really nice but even there I added 1" ram balls and arms on my triple stack mount and screw those into the deck which makes it rock solid.