Just purchased this rig and I am disappointed/confused in the performance. I just had them go through my motor, on the Dino spec. is 46-51 psi at 5000 rpms. Mine was putting out 54psi so it’s strong and I believe I can rule out the motor. I ran it yesterday with full gas tanks and a fishing load, water temp had to be 50ish and air temp was 60. Hole shot average is 3.8 seconds, rpms were a strong 5900, speed was mostly 61.4 and messing around with trim I got it to 62.1 briefly. I also ran with full tanks and empty, similar conditions out side and I ran 6000 rpms, and top speed was 65 but mostly ran 63-64. I had an older SX190 (2002) and I don’t feel this newer boat gets near the lift as the old one. I am running a 25t1 with a 12 inch manual plate. I did notice there is a wedge on this plate. Most everything I have read says this boat should be 67-72 range consistently. My plate is at 4 dots and with the rpms where they are I don’t see raising it. My PTP is 3 3/8. I feel like I must not have any cup left in the prop and maybe a lot of slip. The previous owner was a wizard on the electronics but did little in the maintenance and performance. Any ideas would be appreciated! Thanks