The carpet by my rod locker is loose so when I open it up the carpet on the edge lifts up with it. I figure I can just put some adhesive under the carpet where the adhesive failed. What do you guys use?
The carpet by my rod locker is loose so when I open it up the carpet on the edge lifts up with it. I figure I can just put some adhesive under the carpet where the adhesive failed. What do you guys use?
I've had luck with the 90 3M spray adhesive. Try to clean some of the old adhesive first clean with acetone and then a shot on each surface let it set up and it hasn't moved since.
Scott
2016 Nitro Z20 Pro
Serial # 2B125401 - 250ProXS DFI/TM2
Weldwood contact cement.
https://www.dap.com/products-project...wood-original/
BCB Puma STS
Merc 250
Thanks for the responses so far. I have an aluminum boat if that matters so my decking is aluminum
3m or Weldwood will work. I have aluminum lids on mine and I recarpeted it using the Weldwood contact cement. Works very well. Clean under the carpet then put either glue on both sides and let it set up then attach.
Contact cement worked for me.
2020 Nitro Z20 Pro Package
3M makes very good products.
Rubber cement/ contact cement. Apply to both sides, let tack up and get it down one time with no wrinkles as its not moving again. So practice dry before hand haha
Contact cement.
Lightning 6
2007 TR-196DC
Thanks for the replies. What do you use to get all the old adhesive off? Just scrape off what I can?
In a lot of cases you won’t need to remove it…applying new could reactivate the old.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com