Hey guys I have a 2009 Mercury Optimax ProXS 250 Two Stroke Serial Number 1B764513 and model number 1250P73ED My engine mounted oil tank level sensor has went out and I have ordered a new one and the Special zip ties that go with it. I have a zip tie gun to install them but can’t find anything about what the tension strength it should be set to for installing them. (The tensile strength) if anyone knows I would greatly appreciate that. Also I called the local marine shop and asked after install could they do a hook up and prime my system. They told me fill half full and crack the top and crank it up and let it bleed completely before screwing the top back on. Should I call another marina and take it for the priming or is this correct? Thanks guys. I know it’s a easy replacement but I feel that it should be primed and then bled. But they acted like it was no big deal on the phone. Like stated any help would be greatly appreciated about the tensile setting for installing the ties for the oil lines on the engine mounted tank. You guys have a awesome day.