Hey y’all, I need some help troubleshooting my trailer hubs. It is a triton single axle trailer, no brakes, and I believe it has EZ hubs or some variation. Maybe a year ago, I attempted to degrease my hubs by attaching to the zerk fitting, and attempting to pump grease until I saw clean white coming out the front. Well after what seemed like an excessive amount of pumping with nothing but dark grey coming out, I decided it was probably ok and went on to the other side, which I only gave maybe 5-10 pumps, it’s hard to remember now, but I definitely remember one being filled more than the other, although I couldn’t tell you which side is which. Well, fast forward to now and I’ve noticed one side has grease leaking from the front rubber cap, and being flung all over the hub. At first I wasn’t sure if it was new or old, so I did my best to clean the rim, jacked the trailer up to see if there was excessive play in the wheel and it was tight as could be. maybe 100 miles of towing since then, and it’s definitely new grease coming out. Is there a way for me to tell if this is just simply the side I overfilled and it’s just excess flowing out, or could I have potentially blown a seal? If I had some guidance on what to look out for, I can probably check it out tonight and get some pics if that helps. For reference I used a hand pump, and I haven’t noticed any grease coming out the back side, only the front from under the rubber cap. I don’t remember what grease is in the tube, I want to say it’s mercury 2-4C. Thanks in advance for any advice, last thing I want is to blow a hub on the highway.