Hey guys. I'm on my second build, this is a spinning rod.
Started wrapping guides last night and couldn't get the first guide at all. Took "pre-ground" guide out and ground it. The guide kept "squirting out" on me. Backed off, tried to wrap ahead and pack down -- squirt. GAH.
Ok, I was a little tired and frustrated, but here's my Question. I'm using a CRB hand wrapper. Is it possible to have the thread tensioner TOO TIGHT?
I've been going over this in my head during the night and this morning, about all I can think of other than exercising more patience.
Thanks in advance.
Scott