Thanks Don will get this one load tested then follow your instructions.
Just get a little worried when out on Lake Erie and engine doesnt want to turn fast enough to start.
Thanks Don will get this one load tested then follow your instructions.
Just get a little worried when out on Lake Erie and engine doesnt want to turn fast enough to start.
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
Which battery should I go with that is the least expensive yet still meets the requirements? 08 250 pro xs, graphs, livewell, etc.
Can this Battery thread be updated to include Lithium Starting Batteries?
The cheapest battery that meets the requirements probably won't be very good in a bass boat. The requirements in this thread pertain to operating the outboard and associated equipment which means 800CCA and 135 minute RC. An Interstate 24M-XHD meets that requirement for $123, but you will not be happy with it if you have electronics and try to run livewell pumps and shallow water anchors etc..
The Duracell 31 marine AGM from Sams is the cheapest I'd even consider at $180, but if you put much of a load on it may not last a long time. 800CCA and 200 minute RC.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
https://shop.advanceautoparts.com/p/...1p30/2100010-P
Dont let the Farm and Truck label fool you. This is one powerful battery ( check the specs only ) and you get another 25% off if you give them your email.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 48 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
I was advised by Battleborn Lithium batteries that their lithium batteries, although have worked, they still would not advise them as a starter battery. Trolling motor batteries only.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 48 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
I've got a limited amount of room where I can put my cranking battery. I need a battery that has a max length of 12". '08 250 pro xs, power poles, livewell, graphs. Is the odyssey pc1500 my best bet?
You are just over the threshold with that battery, so it’s not a good choice considering it’s $300 IMO. But if space is that tight you might not have a good choice. If you don’t tournament fish, don’t have a big electronics load and you run the outboard a lot, you might be okay. Otherwise you need to figure out a way to get a bigger battery in there.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 48 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Currently have an Interstate 24M-XHD, which came from the factory on a new '18 Nitro Z19 Sport with a Merc 150 fourstroke. I have tons of room in the rear compartment for a larger battery. Just installed a Noco Genius to charge/maintain. Pretty vanilla setup.
I've outfitted the boat as a striper machine, and when I go out the average trip will be 8 to 12hrs. Don't really want to depend on alternator charging, as it's often been the case that long runs are infrequent.
I want to ensure that my battery will be able to crank the 150 a few times and at trip end, considering the following draws:
- HDS Carbon 12, operating for 8 to 12hrs;
- StructureScan 3D module, operating while Carbon is on;
- 30 gallon standalone bait tank for shad (powered by 500gph pump, ran nearly constantly);
- standard marine stereo, no amp, for background tunes; and
- boat's LED navigation lights, usually on all night long while striper fishing.
I'm thinking the factory battery isn't gonna cut it, and I don't want to risk a 5+, or many more, mile limp back to the landing with the trolling motor.
I want to stick with lead acid for consistency with my TM bank. Thinking that a decent 31 size cranking battery would be a worthwhile upgrade. Max budget is $250. Any advice? Thanks.
X2Power Premium AGM BCI Group 34M Dual Purpose (Starting/Cycling) Marine & RV Battery. You won't be disappointed.
Batteries Plus, 10% off when you buy online and pick up in store.
https://www.batteriesplus.com/produc...ls/sli34agmdpm
Throw in a set of jumper cables just incase.
Last edited by Ed R; 01-13-2019 at 08:17 PM.
Ed R.
2006 ChampioN 198 225 Optimax
Quick follow up question: Guy in one of the stores seemed to suggest that the X2Power 34M wouldn't be significantly different than my current Interstate 24M-XHD, and that maybe it was the X2Power 27M or, certainly, the 31M that was being recommended. Thoughts? Thanks!
Last edited by Savage; 01-29-2019 at 07:02 AM.
+1. The NOCO Genius doesn't care about your TM batteries, each individual charger bank is independent of the other and will automatically detect correct profile for battery that bank is connected to. I've had a Gen 3 on my boat for 7yrs connected to a PM-1 (now Northstar 31AGM) and two wet cell, lead acid batteries for my trolling bank. Contact NOCO (what I did when installing the Gen 3) and you'll get the same info.![]()
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax