Power Poles

[cmtbasser]

I lucked into a power pole pro , I am going to install it next week,( wish it were two to help with wind pivot)

Can some one with a PP post a pic of their brackets?

[xpress spanky]

Here is a couple of pics of my port side mount for a Bullit from Hydrilla Gear.I did have to drill the side of my CMC 10'' plate to mount it,but it's as solid as they come and fits very tight to the motor.It also clears with my 115 which is the same width as a 2.6L V-6. It will hit IF the motor is tilted up and turned,but will not while anywhere in the trim range.

[cmtbasser]

Well I just went straight to the transom on mine it's very solid. There is a brace inside the transom directly under the lifting ring so I straddled that. There was a little flex so I'll watch it close. I did shoot some foam into the void to help out w strength.