Power pole hydraulic lines install pics.

[jdweber14]

I have a 20 i and just order a power pole from Hydrilla Gear I wanted to see pictures of how people ran the hydraulic lines. I would like to not have to drill holes in the cap. I have heard of people running them through the engine harness by cutting a small whole and then putting wire ties on each side. I have also heard of people being able to fit it through the rub rail section where my temp probe is running through. I would appreciate seeing pics of your installs if you have them. Also where have people mounted the pump. I have and Hpdi so I have to deal with the oil tank. I'm looking for the easiest and cleanest way to install it when it arrives.

[unpaulie11]

I ran mine through the top cat where the temp sensor probe runs. I will click a pic tonight. I did have to cut the plastic a little the get the lines to fit.

Got mine from Rich as well great guy!

[Meleagris1]

I had them mounted through the cap on mine, when done right I think its the cleanest and most straight forward way to do it. Power pole lines are on right, Jackplate lines on left.

[unpaulie11]

One other thing to note if you are getting Series 2 Power Poles they have larger hydro lines.

[corybyrum]

[Rodney Bledsoe]

More great info, I've pinned a short cut in the rigging post

[jdweber14]

Thanks for the pics, they have given me some good ideas.

[BasSlayer82]

Trying not to hijack here but can you guys post pictures of where you mounted the pumps and reverse relay on those 20 iclasses, Iam about to do an install as well, so trying to get some input!

Thanks

[DONS9999]

May I ask what the part number of the adapter plate you used is?

[DONS9999]

May I ask what the part number of the adapter plate you used is?

[DONS9999]

May I ask what the part number of the adapter plate you used is?

[Cclutter1]

Mines a 7 inch setback and a 5 inch rise on a zx 225

[DONS9999]

Thanks. Is it a side mount on the jack plate, or a plate that mounts between the motor and jack plate or transome and jack plate???
Is there anyway you could post a picture of it? And do you know the part number?

[Cclutter1]

Part # is pk-7-5- p-blk. The p is for port and the blk is for black in color. That is for the one that goes on the side of the jack plate from hydrilla gear.