need help

[posse1]

does anyone have experience in removing the passenger console on a skeeter boat? Does it look like factory when removed? what did you do with the bolt holes?
I am looking a dual console boat and want to remove the passenger console since i think it takes up too much room.

[Rodney Bledsoe]

Wayne welcome to BBC

My understanding if it's a new model it can be taken out, if an older model it'll look like crap unless your good at re fiberglassing.

[posse1]

thanks for the reply. i am looking at a 2007 model zx 200. the dealer says that they can remove the console but i am worried about the bolt holes. they say they will put the bolts back i the same holes. wonder how that will look. any thoughts?

[30coupe]

If it can be taken out that easily, it should go back in the same way. Try it and see how it looks. If it looks too bad, put it back. How many bolt holes will there be? An alternative to the bolt heads might be those plastic push-plugs that snap in, especially if you can find a close match to your glass.

[posse1]

thanks for the tip on the plastic plugs i will try to get them it looks like there are 6 or 7 bolts

[Jack Yates]

Don't try to glass the holes. Leave it where you can replace it when you get ready to sell or trade. A dual console boat is somewhat easier to sell on the open market. JMO.