It was suggested that I check the poppit valve for obstruction which may be causing low water pressure readings... Can any one tell me where the poppit valve is located.. Motor is a '08 225 series 2.
It was suggested that I check the poppit valve for obstruction which may be causing low water pressure readings... Can any one tell me where the poppit valve is located.. Motor is a '08 225 series 2.
http://www.bbcboards.net...age=1
This post is very helpful. Best of Luck...
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DavidnTex »</TD></TR><TR><TD CLASS="quote">http://www.bbcboards.net...age=1
This post is very helpful. Best of Luck...</TD></TR></TABLE>
too bad the pics were downsized. I have been asking for regular size pics in that post for a while now....no luck
Helped mechanic check mine yesterday...cowl off, back side...see 2 of the 8 screws with bolt head...you will need 2 guys to put it back...the strong spring has to be held down while you put the 2 screws back...plastic cover has to come off 1st also.
(I had low psi but no buzzers even at 70mph...blew thru gauge line...now p valve is clean...so its the gauge oe the 89-95 degree water or both...we shall see tomorrow which one...some guys in La.-Tx swear its only the July-August 90 degree water temp...can't say but it pees fine...
2018 Z19/200 Optimax 2 stroker 24x3 Fury Ultrex 112
Lowrance HDS 12/9 Lives with AT 2
Do finger exercises beforehand, there's no way there's enough room for 2 sets of hands to get in there, it was a pain in the ass to do, but it makes a big difference after replacing the old parts.
2013 Skeeter MX1825 with Yammy F150 & Garmin Ultra 106sv & LVS34 Livescope
"My hotfoot pedal goes to 11"
Reply With Quote