thought i would share what i found last friday,,,
boat info,, 07 20i/ 250hpdi(non series2)
installed a power tec 25---- 15 1/8,, (had little cup put in blades)
motor 1 7/8 in below
3/4 fuel, 4 batteries, 1 person(220lbs),LOTS of fishing stuff!!!
live wells half full, no fish(sigh...)
air temp---97
wat temp---91
little or no wind
gps at 4000rpm 45.9 (water preasure--10-12lbs)
gps at WOT(5600) 74.3 (water preasure--12-16lb
hole shot seems to be close to before
did have alot more bow lift, which in my opinion is needed with this heavy boat
boat handled well, stayed on plane better, and at lower speed
took alot less trim to get top end, which again, IMO, the closer you are to netural trim, the better the boat rides and performs. GOOD THING!
prop looks like a 25T withthe exception of the blades being beefier, i did have to add a washer to get the safety key to fit (to my liking)
i am going to run this settup a while or at least till i make a river run with
another person and more gear. i know i have room as far as rpm goes, because i have seen 6000 in the fall or winter( i have pretty much outgrown running WOT). another thought, not really a concern is the water preasure, like all hpdi's running here in the south, in the HEAT, its not as much as i would like to see.
comment if you wanta