Being the pedal is going to be recessed with the installation of a comfortroll, did you have to figure the pedal location closer to the seat pedestal base? If so how much?
Being the pedal is going to be recessed with the installation of a comfortroll, did you have to figure the pedal location closer to the seat pedestal base? If so how much?
1994 PROCRAFT 180 Dual Pro / MERC 150 EFI
Bill,
Once you remove the front panel, you'll see what room you have to cut the hole. There's "stingers" or support beams that run north and south, east and west so to speak and the comfortroll at least for me fit in the one and only place it could without me cutting across any support. I have a 225 and the peddle is actually closer to me than it was before, but since I stand more "upright" it's actually more comfortable and way less stressful on my back. I really only use the seat pedistal for leaning and balancing now. Other's will probably chime in, but my first recommendation for you is to remove the front cover and take some pictures with a digital camera so you can see what's under there. Also, if you can remove your forward storage box to get a peak, that would probably also help you. Study this through, cause you only get 1 cut. BTW, it might help to know what Model boat you have for others to chime in with advise,etc..
- JEff
1997 ZX185c is the model.
1994 PROCRAFT 180 Dual Pro / MERC 150 EFI
I have done this install on my 1997 ZX 185c and I posted some pictures on the site. Email me and I can send you some pictures of what the underside will look like as well as the install.
Here is the link to the post:
http://www.bbcboards.net...13446
This will be a great addition also, I am very pleased with mine.
fastlife
2001 Skeeter ZX225
2001 Yamaha VMax 225 OX66
cool, looks good-thanks. I have access to a sheetmetal shop and had one formed up from stainless-hope it looks ok.
1994 PROCRAFT 180 Dual Pro / MERC 150 EFI
Reply With Quote