Guys need help

[225proxs]

I have a 1994 Intimidator and I trying to get to back of bench seat bolts to remove seat to send to Mary Kay but the tank will not come up through opening. I have everything out but it seems tank is wider than opening, I can see the bolts but can,t get my arm back to them. Any suggestions or am i doing something wrong.

[silverspook]

Had the same problem with my 95. I moved the gas tank toward the motor and used an air wrench to loosen the bolts. It might help to get someone with smaller arms to help. The air wrench did the trick. Good luck

[225proxs]

OK I have taken the three nuts off the back of the seat but seat still seams solid is there something I have missed????? How does the seat come out

[lunkerhead]

At the bottom of the seat if you unsnap the fabric from the frame there should be a couple phillip head screws.

[225proxs]

Removed the two phillips head screws one on each side but top is still solid.

[Intimidator1]

They fit real snug. I just removed mine and had to pry up on one side and work it back and forth. I had to gring the rear opening 1/4" larger on each side to get the tank out.

[225proxs]

Thanks for the tip on grinding that is what I did and was able to get the tank out. This was a tuff job to say the least, But thank you guys for all the help.Also I contacted Gambler and talked to Mike he was a great help. Gambler customer service is first rate in my book Thanks again

[low slung cruiser]

10-4....on the grinding...