Anyone have a link to explain what all is needed to hook up a water pressure gauge to this motor? if it would be easier to explain the materials and hook-up i would appreciate that also. thanks a lot.
Anyone have a link to explain what all is needed to hook up a water pressure gauge to this motor? if it would be easier to explain the materials and hook-up i would appreciate that also. thanks a lot.
I don't have a link, but the water preasure connection you will hook up to is on the Port side on the outside bottom of the left bank, close to the head. You may have to remove the lower cover to find it.
There is a fine line between \"FISHING\" and just standing in the boat going through the motions!!!
thanks a lot. i just dont want to mess anything up. i am generally mechanically sound, but i would hate to tear something up and have to ride 4 hours to the shop.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by OrygunBasser »</TD></TR><TR><TD CLASS="quote"> the Port side on the outside bottom of the left bank, close to the head. </TD></TR></TABLE>
Hmm, I thought it was to the fitting on the port head itself ?
The new guage will have complete instructions on where to hook up.
the "new" gauge is used and didnt have the instructions.
My Faststrike(same motor) hooks up on the starboard bank, middle cyl. about 2 o'clock from the spark plug. You should see a plug there. Get a 90* fitting(mine's plastic) with a nipple thats same as gauge nipple. 1/8"? Point 90* down, feed hose under carbs, through where the gas lines come out motor and on up to dash. Does this help? Good Luck.
Either side head doesn't matter.
Reply With Quote