Im replacing the trailer on Monday and will have more pics.
Im replacing the trailer on Monday and will have more pics.
Hell yeah. Badass ride buddy....
Thanks Coastal!! now for some seat time...
I thought I would be on Easy Street by now but somehow I missed the off ramp!
Beautiful boat. Congrats
Thank you guys...
Thanks Cleveland
Where are you getting the trailer from? May be looking to replace mine soon.
I had a 91 Skeeter that rotted out that was 20ft also, so I put that trailer under moved all the bunks to fit the Cobra. My friend owns Nextrail Trailers depending on how much you want to spend I could get a pretty good deal for you, all his trailers are aluminum.
thanks keefus
What an awesome looking rig!
I have the same motor on my 201DC and absolutely love it. It sounds like a race car, hauls butt like a race car and drinks gas like a race car.
If your looking for more speed I can tell you by just looking at it the motor is way too low.
hydraulic jack plate and I pull it down while being transported. is that what you mean. I put it up when on the water.
I ran 74mph (gps) at 5800 rpms today, started chine walking I think it has air the steering so Im going to bleed it and see what happens.
You`ll need to find the sweet spot for your jack plate setting. My prop shaft is 1" below pad, but yours may need to be higher or lower than this. Just make sure you don`t drop below 12# of pressure while running.
The chine could be caused by the motor being too low. That motor should turn around 61-6200 rpm. You get it that high and your going to have one fast boat.
When I bought my boat it chimed so bad above 65 mph I couldn`t control it. The higher I raised the motor the less it chimed, and the faster it went.
What prop you running? You should be approaching 80mph with tha XB250 beast!
I thought I would be on Easy Street by now but somehow I missed the off ramp!
25 pitch tempest I believe
25pitch tempest plus
Reply With Quote
