Results 1 to 7 of 7
  1. #1
    Member HatfieldHog's Avatar
    Join Date
    Aug 2010
    Location
    Mtn. View, Arkansas
    Posts
    1,590

    Trolling Motor Issue...

    For all you guys with diagnostic minds, here's my situation. It seems that when I go out on cold mornings, I have no power to the trolling motor. After it warms up, it starts working again. Is there a relay or breaker that could be going bad? I know it's an unusual problem, but, if you have any answers, I'd value them.

    BTW, I have a '99 181 Champion with a 24 volt MotorGuide 82 lb. trolling motor.

    See ya, HatfieldHog


  2. #2

    Re: Trolling Motor Issue... (HatfieldHog)

    Check all your connections, like at the batts., and on the bottom of the TM Foot Controller. Tighten any loose connections and clean any corroded connections/terminals. Cooler temperatures will cause metal to contract, and may be causing a poor connection.


  3. Member
    Join Date
    Jul 2005
    Location
    So. San Francisco
    Posts
    238
    #3

    Re: Trolling Motor Issue... (HatfieldHog)

    I agree with the connections. Moisture and corrosion usually is the cause of your problems. I would redo the motor connections by removing each connector cleaning the wires good attaching them with shrink connectors then silicone them. I have two boats and it has happened to me many times until I corrected it.


    [B]Dale 1991 Champion 184 DCR Mercury 175 ProXS

  4. Champion Boats Moderator Lea's Avatar
    Join Date
    Jul 2004
    Location
    Franklin, VA
    Posts
    48,853
    #4

    Re: Trolling Motor Issue... (Sumo)

    Same thing happens with my 4Runner's radio speaker!!!! No sound when cold, but just fine once truck warms up a bit. I know I have a loose connection, but hate to have to contort to get under/behind dash...

  5. Member HatfieldHog's Avatar
    Join Date
    Aug 2010
    Location
    Mtn. View, Arkansas
    Posts
    1,590
    #5

    Re: Trolling Motor Issue... (Lea)

    Hey gentleman, here is an update on how my trolling Motor is acting! I took it by the boat repair place and they changed a couple of connections and it worked. Next morning, I got to the lake, and it wouldn't work again. I was fiddling with the switch on the front of the footpedal, and it wouldn't work at first, then, it started working on "High/Bypass" only, then, and couple of minutes later, it started working correctly. Sound like the "mode" select switch on the front of the pedal to you guys? If so, will MotorGuide sell me one? My TM is the MotorGuide Digital Tour 82 lb. 24 volt.

    Thanks for the help, HatfieldHog

  6. Member
    Join Date
    Jun 2009
    Location
    Dunsmuir, Northern California
    Posts
    5,517
    #6

    Re: Trolling Motor Issue... (HatfieldHog)

    Talk to board sponser Jones trolling motor,,sounds like the switch.IMHO

  7. Member HatfieldHog's Avatar
    Join Date
    Aug 2010
    Location
    Mtn. View, Arkansas
    Posts
    1,590
    #7

    Re: Trolling Motor Issue... (siskiyoucrash)

    Thanks, the guy there was very knowledgeable and happy to give me advise.

    See ya, HatfieldHog

Similar Threads

  1. Replacing Minn Kota maxum pro trolling motor, "motor rest bracket"
    By fishermanchief in forum Bassboat Restoration
    Replies: 1
    Last Post: 10-10-2011, 12:49 PM
  2. cajun electrical issue with trolling motor
    By currentobsession in forum Cajun Boats
    Replies: 2
    Last Post: 06-25-2011, 10:03 AM
  3. Still having a trolling motor issue
    By ZeroHour in forum Skeeter Boats
    Replies: 3
    Last Post: 09-15-2008, 04:41 PM