i have a 1991 johnson gt200 the exhaust has been drilled out and it has a housing on the mid section. where can i get the plugs to plug the two holes in the housing. thanks
i have a 1991 johnson gt200 the exhaust has been drilled out and it has a housing on the mid section. where can i get the plugs to plug the two holes in the housing. thanks
How big are the holes? If not too big mix up some Marinetex and let it harden 24 hours.
Originally there were rubber plugs with a washer on each side with a bole through them. They could be tightned up to seal or opened up for performance.
Go to http://www.pitstopmarine.com click on the performance products then Bob's Machine-----you should see what you need and inquire there. Good luck...
I think you can also go to an auto parts store and get freeze plugs that you can put in an engine block, not sure what they are called though.
_________________________________________
96 Javelin 379SE 96 Johnson 150 (J150ELEDB)
Mods: FS carbs, Ficht reed cages, boyesen reeds and
Baker Hot Heads.
Reply With Quote