after the can is empty is it ok to let mtr sit about 20-22hrs rather than 3-16
then restart to clean out?
on hose where should i run at (rpm) rusty mentioned somthing about under 1500. didn't quite comprehend
after the can is empty is it ok to let mtr sit about 20-22hrs rather than 3-16
then restart to clean out?
on hose where should i run at (rpm) rusty mentioned somthing about under 1500. didn't quite comprehend
Don't let it go past the 16hr mark metal may start to migrate/adhere to other internal things. 12 hours is good enough just watch the tach and keep it below 1500. CM
The main concern on the rpms is to keep the motor from dieing while you decarb, there is no need to rev the motor anymore than it takes to keep this from happening.
Make since?
Reply With Quote
