It was running just fine, I went to crank back up to head to the ramp and nothing. It makes the indicator beep and the primer works but when I turn the key I don't get anything? Can anybody help? I am first going to look at the neutral safety switch in the control panel where the key and throttle is? Thanks
Don't forget to check the battery and starter connections. I had a problem a few weeks ago, with my first start-up of the year. The starter would engage, but not spin. Turned out to be a little corrosion on the battery connection. It don't take much.
Also, you could wiggle the shifter a little bit as you try to start it, just in case the NSS is acting up. This might tell it.
Modified \'92 Procraft 170 Combo/\'97 Johnson 130<U></U>
I found out its the stater solenoid thats gone bad. How hard is this to get to and replace? Anybody know? Thanks
No message except here is Bay Marine's contact info:
BAY MARINE INC
2394 N COBB PKWY
KENNESAW GA 301523675 (770) 427-3578
BRP part number is 586180 about $36.00 you can also use a Merc solenoid part number 47886T also about $36.00. Your BRP dealer should have them instock.
Reply With Quote