it's a LITTLE bit of work but it's pretty much a beginner level job. You can run wires to each comp if you want, OR tie into existing. I'm using the courtesy lights that are in the compartments and near the steps. Just tapped into that circuit and tied the wires up out of the way.

I put a longer piece of heat shrink on the wiring at the LED, measured it and drilled a hole that size so it's tight and seals up when you pull through.

Word of caution - if you're working from inside a compartment and look up into the gunnel (looking to hide wiring), more than likely it's not finished fiberglass and some of it can stick out like a needle and stab you - just be careful or wear gloves.