Work up this morning and the house was around 55 degrees, the furnance was working when i went to bed last night. . . switched off all the circut breakers for 15 minutes then turned them backon. no heat. . . Went to Lowes and pickced up a new thermostat, but that didn't help, still no heat.
The system is a two stage heat pump. . . Anybody got any ideas of what to check before i call somebody that will cost me $$$$
Thanks
.
.
.
.
.
.
"Success is never owned, it is rented, and the rent is due every day."
Compressor turn on at all? Fan motor on the unit? Did you try the AC?
Basscat!
If it was gas heat I could help. Service tech for 14 years but we don't have heat pumps up here. Make sure compressor is coming on. if no, possibly a bad capcitor. If yes does your fan come on... start with the basics...
Does anything happen when you switch to emergency heat setting?
1996 ProCraft 185 DC Pro, Mercury EFI 150
Check the fuses in the disconnect outside. Take the side cover off and Press the contractor and see if fan runs and compressor .
it's and electric heat pump. i can hear the thermostat click on. but i get No fan, No compressor.
When i flip it to emergency heat, i still get no fan, and no heat. . . . .
"Success is never owned, it is rented, and the rent is due every day."
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by GRR884 »</td></tr><tr><td class="quote">Compressor turn on at all? Fan motor on the unit? Did you try the AC?</td></tr></table>
No Compressor, No fan, too cold to try the AC.
"Success is never owned, it is rented, and the rent is due every day."
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by haha »</td></tr><tr><td class="quote">Does anything happen when you switch to emergency heat setting?</td></tr></table>
Nothing happens, no fan no heat.
"Success is never owned, it is rented, and the rent is due every day."
is there a zoning board ? if so, check the fuse....sounds like youve lost a control circuit..there should be a fuse for the control transformer somewhere....either at the air handler or the condensor....most likely the A/H....
might as well call hvac guy at this point........
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by sclark »</td></tr><tr><td class="quote">
No Compressor, No fan, too cold to try the AC.
</td></tr></table>
there should be a 3 amp fuse on the circuit board inside the air handler.check that first.sounds like you have no control voltage.
NOT ALL WHO WANDER ARE LOST!!!!!!
Checked the 5amp fuse in the air handler - it was popped.
Replaced it, the system ran for a few minutes until the outside unit kicked on then it blew the fuse again..
Called the service company took them less than an hour to fin the short and correct the problem - wow i have heat again . . . .
.
.
.
.
.
.
.
.
"Success is never owned, it is rented, and the rent is due every day."
Had this kind of happen to my electric heat pump. Although I still got heat running on Em. Turned out my outside fan unit thingy switch was turned off. It's outside in a small box beside the fan thingy. As for the actual electric heat itself? Maybe a switch on the main unit? Also check your thermostat. Had that happen a t home and it turned out it got bumped and was shut off.
Reply With Quote
