Results 1 to 3 of 3
  1. #1
    Great Lakes Captain RangerTim619's Avatar
    Join Date
    Aug 2004
    Location
    Swanton, OH
    Posts
    1,182

    Trim and Tilt not working 200 ficht

    It worked fine all day than when I went to put the transom saver on, Nothing ! Then to make matters worse the screw driver came out of the slot on the manual release and my feet slipped and down she went all the way to the ground. Could not raise her by hand had to use the jack from the truck.

    My question is where will I find the fuses for the trim and tilt? My ficht is on a Ranger 619 I have checked the fuse for the front panel switch. Is there an inline under the cowl? Or could there be an other location for some fuses?

    Any help would be Great.

    At least I had a good day of Fishing!

    Ranger Tim

    Ranger 619 * Honda 200* Minn Kota* Humminbird *Garmin
    Fenwick *Abu Garcia

  2. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #2

    Re: Trim and Tilt not working 200 ficht (RangerTim619)

    Right side of the motor (from behind).....black cover two slotted screws...Power Distribution Panel (PDP) remove the cover and check the fuse between the relays, if its not blown you may need a PDP.

    You did not post if the motor would still crank over.

  3. Great Lakes Captain RangerTim619's Avatar
    Join Date
    Aug 2004
    Location
    Swanton, OH
    Posts
    1,182
    #3

    Re: Trim and Tilt not working 200 ficht (RUSTY63)

    Rusty

    Yes, the motor will crank over and it was running fine all gauges and other acc. were good too.
    Ranger 619 * Honda 200* Minn Kota* Humminbird *Garmin
    Fenwick *Abu Garcia

Similar Threads

  1. Power trim /tilt stopped working now working
    By Fish4fun24 in forum Mercury - 2.0/ 2.4/ 2.5 Liter High Performance
    Replies: 1
    Last Post: 09-04-2011, 06:00 AM
  2. Tilt/Trim quit working.
    By TerryMSU in forum Evinrude/Johnson Motors
    Replies: 14
    Last Post: 06-03-2011, 04:54 AM
  3. 83 Evinrude 150 Tilt and Trim Stopped Working
    By rgunsiorowski in forum Evinrude/Johnson Motors
    Replies: 0
    Last Post: 09-29-2008, 10:38 AM
  4. tilt & trim not working properly
    By shawn16 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 03-06-2007, 03:15 AM
  5. tilt and trim not working
    By mossboss in forum Yamaha Motors
    Replies: 8
    Last Post: 06-27-2006, 12:50 PM