Thread: trim help ??

Results 1 to 8 of 8
  1. #1
    Member shawn706's Avatar
    Join Date
    Dec 2004
    Location
    Colbert, Ga
    Posts
    2,812

    trim help ??

    My trim works fine when I'm not moving. But won't come up under power.
    HELP!!!

  2. Member
    Join Date
    Jun 2004
    Location
    Fayetteville Tn.
    Posts
    3,556
    #2
    sounds like it is leaking back past the seals......

  3. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #3

    Re: (THE WITCHDOCTOR)

    Try this, trim the motor down on a block of wood, release the manual release valve and run the trim up then down for 30 seconds, the motor should not move, tighten the manual release and see if that helps.

  4. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,181
    #4

    Re: (RUSTY63)

    And see if your fluid is up to the bottom of the reservoir too. CM

  5. Member shawn706's Avatar
    Join Date
    Dec 2004
    Location
    Colbert, Ga
    Posts
    2,812
    #5

    Re: (RUSTY63)

    thanks for the advise guys.
    Is there a place on the web that I can look at some pics of what your talking about because I know nothing about trims except push one way for up and one way for down.

  6. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #6

    Re: (shawn706)

    The manual release is on the left side (from behind) in a hole in the mounting bracket (slotted screw) turn it counterclockwise to lower the motor.

    To check the fluid........raise the motor all the way.on the right side (from behind) there is a large slotted screw on the reservoir....remove it and fluid should run out....if not add some Bomb trim fluid.

    Hope this helps.

  7. Member shawn706's Avatar
    Join Date
    Dec 2004
    Location
    Colbert, Ga
    Posts
    2,812
    #7

    Re: (RUSTY63)

    Rusty, I'm getting ready try what you said. Should I expect for fluid to come out of the manual release, and will I drain my reservoir when I trim up and down for 30 sec? Also I checked fluid level and it was good.
    Thanks

  8. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #8

    Re: (shawn706)

    No fluid should come out, back the manual release out to the clip that holds it in and Stop.

Similar Threads

  1. Question about trim rods and removing trim caps.
    By kyle31 in forum Yamaha Motors
    Replies: 3
    Last Post: 03-13-2011, 09:00 PM
  2. Replies: 4
    Last Post: 01-24-2011, 11:53 AM
  3. Trim "Jerking" through Movement When I Trim Down During Idling
    By champ203rude in forum Evinrude/Johnson Motors
    Replies: 12
    Last Post: 08-11-2010, 05:19 AM
  4. Question on Teleflex Pro Trim (flasher type trim control)
    By Triton85 in forum Novice Boaters Forum
    Replies: 3
    Last Post: 02-02-2010, 04:35 PM