Results 1 to 8 of 8
  1. #1
    Member
    Join Date
    Nov 2009
    Location
    Lutts,TN
    Posts
    231

    2000 OX66 225hp help please

    I'm afraid I know the answer but I'll ask any way. What would cause the oil and gas mixture to come out of the prop exhaust when the gas bulb is pressed?

  2. Banned
    Join Date
    Jun 2004
    Location
    Apex, NC
    Posts
    4,828
    #2
    Strange...the only way for this to happen is through leaking lift pumps or stuck open injector which is unlikely. Have you checked compression?

  3. Member
    Join Date
    Nov 2009
    Location
    Lutts,TN
    Posts
    231
    #3
    I have not checked compression, however it is only gas , not gas and oil, coming out. I found this after removing the lower unit. The motor seemed to have plenty of power but would run out of gas then run again after pumping the fuel ball.
    Last edited by grassycreek; 04-08-2012 at 08:40 AM. Reason: Misspelled words

  4. Member
    Join Date
    Nov 2009
    Location
    Lutts,TN
    Posts
    231
    #4
    Also, there is no leaks anywhere on the engine under the cowling. Could the fuel pump cause the gas to run out the exhaust?

  5. Member
    Join Date
    Nov 2004
    Location
    Columbus, Indiana
    Posts
    4,247
    #5
    Replace your low pressure fuel pumps.

  6. Member
    Join Date
    Oct 2010
    Location
    Texas
    Posts
    1,642
    #6
    Ditto on the low pressure fuel pumps. You have raw fuel leaking from behind the pumps into the combustion chamber(s). Loosen each pump and pump the bulb. My bet is one or all are leaking like a seive. Check this or you will definately burn a piston. Other option could be a stuck injector.

  7. Member
    Join Date
    Mar 2007
    Location
    Largo
    Posts
    278
    #7
    Quote Originally Posted by 201pro View Post
    Replace your low pressure fuel pumps.
    X2 low pressure pumps


    2002 Pathfinder 2400V
    2002 Yamaha 225 OX66

  8. Member
    Join Date
    Nov 2009
    Location
    Lutts,TN
    Posts
    231
    #8
    Low pressure pumps replaced and it fixed the problem, thanks everyone!