wasn't there a post with pics on removing fuel injectors on a hpdi, i was going to have them checked and just wanted to do a lil homework before i dive in thanks.
wasn't there a post with pics on removing fuel injectors on a hpdi, i was going to have them checked and just wanted to do a lil homework before i dive in thanks.
2007 Skeeter 20i class, Yamaha HPDI 250 "If the boat does not rock on your hookset, you are not setting it HARD ENOUGH!!" **Common sense is not common, it is a function of experience and training**
I don't have pics but it is not a hard job. Remove bolts from the plastic cover on the rear of engine that holds the coils and move it to the side to work on the opposite side. Remove the bolts holding the fuel rail and gently remove it. The pipe bringing fuel to the rail is flexible, move the rail off to the side out of the way. Each injector is held in place by a large clamp held by a bolt, remove the bolt and clamp and pull the injector out. The wiring is marked so you don't need to mark it. Clean the gaskets out of the block and off the injectors and use new gaskets for reassembly. Most all bolts removed will need blue loctite or equivalent on reassembly, you will see which bolts were put in with a thread locker originally.
Thanks for the reply.
would like to see a visual aid on this procedure