Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Jul 2007
    Location
    Newburyport
    Posts
    7

    2001 200HP HPDI Problems

    Hello,
    Please file this under frustration.
    In summary:
    1) Have a 2001 @ 2004 HPDI 200 HP. The 2004 is running fine.
    2) The 2001 has the following symptoms:
    a) Idles fine @ 600 RPM but boggs down & stalls as throttle is advanced (700 to 800 RPM).
    b) Under load (underway), bogs down @ 2100 RPM. When the throttle is "coaxed" beyond 2100 RPM have been able to achieve 3800 RPM @ WOT.
    3) If this was a carburator, I'd say rebuild. HPDI, I don't know. I have YDS files, but I don't know how to link them to this message. The fuel flow figures look OK (under 5psi, but within spec, I believe).
    Any help is appreciated. My girlfriend is about to kill me (after all the waxing & cleaning she did).

  2. Member reelman's Avatar
    Join Date
    Jun 2004
    Location
    Palatka, FL 32177
    Posts
    8,252
    #2

    Re: 2001 200HP HPDI Problems (Sprokit)

    Checked fuel diaphragms yet?
    Not expensive to replace either...been there with my 2000 V-Max...
    not a mechanic by any means, just learned some stuff by 28 years of problems to solve.

    2018 Z19/200 Optimax 2 stroker 24x3 Fury Ultrex 112
    Lowrance HDS 12/9 Lives with AT 2

  3. Member
    Join Date
    Jul 2007
    Location
    Newburyport
    Posts
    7
    #3

    Re: 2001 200HP HPDI Problems (reelman)

    Well rebuilt both low pressure fuel pumps with no change in the problem. Engine will start and idle fines but bogs down and stalls between 700 and 800 RPMs when the throttle is advanced. The pumps and diaphrams looked pretty clean.
    So, I am stumped. To recap"
    All plugs changed.
    VST & water seperator/water alarm (on engine) filters changed
    10 Micron filter has been changed.
    I am going to run the YDS again to see if there are any clues that I may have overlooked. I did notice something strange the last time I ran the diagnostics. The ECM was stating that the engine had over 6400 operating hours on it! Could the ECM have gone bad? Anyway to reset the paramters and clear out any errors?
    Many thanks. This board has been very helpful with info.

  4. Member
    Join Date
    Nov 2005
    Location
    Prairieville, Louisiana / Zolfo Springs, Florida
    Posts
    5,696
    #4

    Re: 2001 200HP HPDI Problems (Sprokit)

    The ECU could very will be the problem but if not check the TPS.







Similar Threads

  1. 2001 200 hpdi problems
    By MIKER2702 in forum Yamaha Motors
    Replies: 19
    Last Post: 12-14-2009, 04:03 PM
  2. Replies: 6
    Last Post: 10-18-2008, 12:48 PM
  3. 2001 Yamaha V-Max HPDI 200hp questions
    By TR-20XGlenn@Home in forum Yamaha Motors
    Replies: 1
    Last Post: 06-14-2008, 06:06 PM
  4. 2001 200HP HPDI Anodes & Water Pump
    By Sprokit in forum Yamaha Motors
    Replies: 3
    Last Post: 03-30-2008, 09:50 PM
  5. 2002 200hp hpdi problems getting past 3000rpm
    By wawa in forum Yamaha Motors
    Replies: 4
    Last Post: 08-04-2006, 09:24 AM