I recessed my depthfinder in the front panel on my new Tracker 175TXW and didn't notice a front deck support was in the way. I extended the hole over but need a plate made to go behind the unit to cover up my mistake. I tried finding someone local with no luck and my first attept to make one myself don't look good. There was a guy on this thread that made them but I can't get ahold of him. Any ideas?
If you mean a plate to cover up the hole so you can mount the unit above it, talk to Sherm.
Sherm's Marine
8662 S 400 W
Wabash, IN 46992
Phone 260-563-8051 Fax 260-563-8748
Email sherm@shermsmarine.com
I know he makes some plates but I am not sure if its what you need. There is a pic posted on Basscat owners Board of one of his plates, http://basscatowners.yuku.com/...t-PIV
Joe Fuerst - Houma, La
[B]2001 Basscat Pantera III / 200 Mercury Optimax[/b[
God Bless Our Troops
Mine isnt in the dash but rather in a panel on the very front on the deck on my tracker. I already cut the hole wider so I could slide the unit over to get around the support. I need a plate with a hole the same size as the back of my x135 but the plate needs to be bigger to cover up my screw up. Sheen may be able to do that, I'll contact him. Thx
Send me your panel and a drawing and ill bet we could get you taken care of. MM
Mark , Ill give you a call on tuesady if that works for you.
Reply With Quote