What way did you do the corners? I've seen two ways: One is the way the Ranger is now and they just cut the carpet on 90* angles so the edges runs right down the middle of the corner. The other way is the cuts are different angles so the edges run across the corner.
So if I haven't confused the heck out of you what way is the way you went? Was it easy or hard?
Thaks
Joe
Joe Galada - Tamaqua, PA
2004 Ranger 521VX - Yamaha 250 SHO
Look at this................
http://www.bbcboards.net/zerothread?id=40840
I went the way Ranger put it in, I have a short attention span so it was less complicated. If it don't quite fit tight at the seam take a rubber mallet and tap the corners together it worked like a charm. To me the lids were easiest things to carpet.
The ranger way.
I have done it both ways...I used to do the way Ranger does now...but have since gone for the other way. To me its all about hiding the seams....if done the right way no one will ever know where you had placed the seams.
DeSean
Reply With Quote