OK...what's my next step (fiberglass repair) minor

[behmer]

Here is where I stand...I cleaned and prepped the glass areas that needed to be touched up. I filled the areas with Marine-Tex and covered with clear tape. It is now completly hard and affixed to the work areas. This is what I think my next steps are: Start wet sanding getting finer and finer as I get along. As soon as I get the Tex flush and smooth with the existing surface, clean and prep again and start the buffing with rubbing compound (white) with high speed orbital buffer, until all scratches are gone, finally apply good coat of wax and enjoy your finished results.

Am I missing anything specific before I start step 2 of this project


Thanks

[Rollo331]

your on track go for it........

[behmer]

Thanks