I have a 1996 115 mercury with what I think is a bad warning module. I'm trying to remove the lower split cowl for better access. The service manual says to remove two aft internal screws and two front screws at the front latch plate. I've done that but it feels like something else in the front is holding it together. The rear is loose. Any ideas?
you get one under the front about 4 inches back ???
.................................................. ...the scariest thing in life is the unknown ...................................
I haven’t seen that one but there has t be something else holding. I’ll look. Thanks!
look between cowling and steering arm
.................................................. ...the scariest thing in life is the unknown ...................................
The bottom cowling gasket and the telltale gasket can trick yah. Think yah gotta take the rigging tube fitting off too?
2017 Phoenix 819
2016 200ProXS, s/n 2B359849, Mod 1200P73BD
Found it! Bottom of cowling, port side. Above the steering arm, hidden by gunk and grease. Thanks guys!
.................................................. ...the scariest thing in life is the unknown ...................................
Reply With Quote