2020 Pro XS cranks but won’t fire

[mbenner]

2020 Pro XS 200 turns over strong but won’t fire. Recently had the lower off for skeg & prop repair, during this time I also replaced the cranking battery 800/1000 and did an oil change. Put everything back together and boat fired up. Two days later I go out and it now turns over but won’t start. When I turn the key to accessory I hear the fuel pump run like normal and get a long beep. At work will update with s/n

[Michael333]

2020 Pro XS 200 turns over strong but won’t fire. Recently had the lower off for skeg & prop repair, during this time I also replaced the cranking battery 800/1000 and did an oil change. Put everything back together and boat fired up. Two days later I go out and it now turns over but won’t start. When I turn the key to accessory I hear the fuel pump run like normal and get a long beep. At work will update with s/n

Killswitch possibly turned off, although I think that’s four separate beeps. One continuous tone is usually guardian mode. It’s in neutral? Sorry dumb questions, but it happens.

[mbenner]

In neutral and kill switch is in run

[Michael333]

In neutral and kill switch is in run

do you have any type of vessel view or the smart gauge on the dash that indicates anything? I know mine went into guardian one time because it was overheating due to grass around the lower unit and it was telling me that was the problem on the gauge.

[mbenner]

I don’t, wish I did

[Michael333]

I don’t, wish I did

OK well you should not have a long tone, mine gives one short little beep when I turn the ignition on before starting. So whatever fault is causing that tone. it’s most likely something simple maybe something accidentally got unplugged while working on the motor. I honestly don’t know. before you take it to a dealer I would just check over your work real good and make sure you didn’t inadvertently unplugged something or something really simple.

[Zone18]

I would go back over your battery connections....maybe you missed one.

[alli ss]

Like both motor power wires, clean power wire would be easy to forget

[mbenner]

I will go back through the battery again, however it did fire once I finished installing the battery. It not firing was once I got to the lake. Turns over strong like it’s just about to fire and then doesn’t

[Zone18]

Going through my proXS tech manual a long 6 second beep can be quite a few things. Check all belts, plugs and connections too...anything that could have been bumped loose or disconnected during service.

[EuropeanAM]

Unless your boat has a battery switch that's in the OFF position, you'll need to get it on the G3 Diagnostic System to determine what that CRITICAL fault is.