So like the title states, my (new to me bought used) Motorguide xi3 is only spinning 360 degrees with remote then stopping. It doesnt matter where i start spinning the unit from , it will stop approx where it started spinning when holding down either left or right. Does not have gps module, i was going to add it but wanted to make sure 1st that things like pin point spot lock would work without the unit stopping if it needed to spin 360 degrees. this is for a small johnboat project, i have an xi5 on my 19 ft. and it works great but can spin endlessly if it wanted to. I dont know if this was a "feature" of older units and maybe needs an update. I can try to hook it to my carbon to see if it will update over nmea.
Just seeing if anyone else has seen this before or dealt with it and how it might have been resolved or its just the way it is. I was going to take apart the transmission but wanted to wait to hear from anyone 1st, everything else works perfect. TIA