Helix/360 wiring question

[pinehawker]

installing a second helix at bow and need some advised. I have a fuse panel at console at helm and currently wire running from there to bow for helix. adding second helix and 360 I am wondering if I can add a fuse panel at bow for the two helix and 360. if so I know helix requires 5 amp fuse and 360 uses 1 amp. what size fuse would I use in the console fuse panel if possible. if not can I connect the current wire to bow to the +post on fuse panel with the battery wire and - to negative then fuse the bow fuse panel? not sure if this is sounding confusing or if I'm making it to difficult. just don't think I can get another wire to bow. Thanks

[chad202]

I recently added a 12" solix and mega 360. I just tapped into the 36V power at the bow for the trolling motor and installed a Bandit DC to DC converter box to run the 12" and 360. I did this because at the end of the day of fishing, I would still have 90% juice left on my trolling batteries. The Bandit is designed to clean up the power and not allow any RFI signals through. I get zero interference from the trolling motor. I installed the bandit under the bow shroud so no extra wires to run through the boat. It has a 36v inlet and 2 exits ports, 1 is 14V which can go you your graph and 360, the second port is 27V which most put to their black box if they live scope.

[Mahomee]

I also just installed a step down converter off my tm 36v down to 24v for my black boxes. Because my tm batteries are always barely down also. I used a inline waterproof fuse also off amazon.

$15-25 on amazon.

https://www.amazon.com/dp/B008CM4WZ2...hlbWF0aWM&th=1

[pinehawker]

Thank you