Hi Folks,

Possibly a "stupid" question..., however I read a lot of posts and note that damage can occur if primers aren't hard prior to starting.

On a couple of occasions (the last being the worst) I have struggled to get the bulb "hard" before the first start. Most recently I was reaching for my tools to change the bulb when it finally came good (say 3-5mins of trying).

Should I be looking at the bulb, the lines (original "black" as far as I know) or other? Note:- the bulb seems to stay quite firm.... once it gets there, engine runs beautifully.

Thanks for any suggestions of areas to check, or reasurance if this is "normal"
Andrew