I have had this issue since the very beginning of owning my 360 and I am finally hoping to get this figured out.
I am running my mega 360 on a gen 2 Solix 15, which is networked to my gen 3 solix 15 at the console. If I mark a waypoint on my side imaging at the console I am hoping to see that on my 360 but dont...any ideas? I do remember seeing them in the past but they were very innacurate so I must have turned a setting off? Thanks everyone
Last edited by nickmcd63; 05-20-2024 at 09:19 AM.
NorthStar Custom Baits
What Heading Sensor source are you using?
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/Advanced, MEGA360,
MEGA LIVE, LIVE TL
AS GPS HS
NorthStar Custom Baits
Can you mark a waypoint on the 360 view?
Do you have the Heading Line turned on for the Chart view?
Does the Heading Sensor control the position icon?
Is Auto-Configure ON for the Heading in the Network menu?
Does it show the NMEA0183 device as the source?
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/Advanced, MEGA360,
MEGA LIVE, LIVE TL
Reply With Quote