-
2019 V6 200 four stroke lower unit
It’s good to be back…
been almost ten years since I was lurking on BBC and it’s great to be back.
im rebuilding my 1998 Procraft Superpro 200 as I received a 2019 200 V6 as a gift from a friend of mine (I know, nice gift)
the issue is this engine is a long shaft left hand rotation.
serial number: 2B574322
model number:12000017A
200CXL
looking to go short shaft and right hand turn, can I just remove the center section, change the drive shaft and gearing and let her rip?
thanks so much for your help.
Aaron
-
Mercury 3L/4 Stroke/Verado Moderator
Short shaft is 15"
Long Shaft is 20"
Xtra-Long Shaft is 25".
The engine you have is a 25". Suspect what you want/need is a 20".
There should be a 5" extension kit that's been added to your engine. Removing that kit, and installing the correct 20" shaft length hardware will rectify the driveshaft housing side.
Gearcase is a little more involved ... driveshaft and shimming can make it a 20" (L) shaft, but it would still be a reverse-rotation gearcase. Either find a RH gearcase, or have that one built up with gear set, bearings, shimming and driveshaft.
-
Thank you so much for your time again Don! When I quoted a new gear case from mercury it was 10,000$ Canadian. Not much of a resale market here for a left had rotation one. When you say build one up you mean just order all the parts separately?
How do you feel about a left hand rotation on a bassboat providing I can find a decent prop?
Thanks again
-
Mercury 3L/4 Stroke/Verado Moderator
Aaron- I think the long-term nagging dissatisfaction with performance and handling will far outweigh any "savings". And LH prop choices are a lot slimmer as well...
-
Really appreciate you taking the time to help us all sir!
-
Mercury 3L/4 Stroke/Verado Moderator