Got a 2.75in tube mold, all is fine with it but cutting the tubes is not going so well. Got maybe 2 dozen cut and the cutter fell apart, the series of razor blades just fell out.
can anyone recommend a cutter that works well?
Got a 2.75in tube mold, all is fine with it but cutting the tubes is not going so well. Got maybe 2 dozen cut and the cutter fell apart, the series of razor blades just fell out.
can anyone recommend a cutter that works well?
Prints and more available at: http://BSPhotography.co/
Digital downloads available at: https://licensing.pixels.com/profiles/1-brian-shoemaker
IG: BSPhotographyZ9
I make a cutter from blades, spacers, nuts and bolts for cutting zonker strips from Rabbit hides. You could make a smaller one for cutting tails - I use double edge razor blades I get at wally world.
100_7270.JPG
I make a cutter from blades, spacers, nuts and bolts for cutting zonker strips from Rabbit hides. You could make a smaller one for cutting tails - I use double edge razor blades I get at wally world.
IMG_0165.JPG
Angling ai did have one. I have the deluxe tail cutter block from lurecraft & built a beefed up version of their press to cut my tube tails with. I did the tail in worm oil, lay them on a block of wood under my cutter & press a couple times & they cut them good.