I purchased some unpainted crankbait blanks and the one that i liked i bought, painted it up, and tied it on, threw it, and it didn't run very well. My question is, the bill is rounded on the front am i able to take the dremel and square off the bill and sand the underneath to make it flat.
It looks like a flat sided lucky craft style. I really like the size of the bait but would like to get it to run better.
Anyone ever experimented with this?
It's easier to ask for forgiveness than it is to ask for permission.
Yes I will take some baits and change the bill shapes,sharpen or thin or even change the weights. Problem is you will ruin a few but if they dont run well anyway your not going to hurt them
They for sure do not run very well, I figured a buck or two to try and see if i can get them to run better.
There is also a dised place in the lip does this need to be there or can i fill it in with something?
It's easier to ask for forgiveness than it is to ask for permission.
around the line tie or just a random low spot?
infront of the line tie, just a dished out spot dead center of the bill
It's easier to ask for forgiveness than it is to ask for permission.
Reply With Quote