View console maps at bow?

[187famous187]

I just installed a 106SV at the console with Navionics Plus maps. It is connected via Ethernet to the 93SV UHD at the bow. My waypoints show up on both units, however the 93 still shows the built in LakeVu maps. How do I get it to show the Navionics maps from the console? Thanks!

[canon]

refer below support doc from Garmin you will know that two wont share the built in map to each other:

https://support.garmin.com/en-CA/?fa...Bi8obELChD8hJ9
https://support.garmin.com/en-CA/?fa...Kc7W9tahwiksw8

[187famous187]

Thanks

[goodman_fishing]

UHD should support the maps just fine, curious what the solution is. You can try the Garmin Express software and see if it lets you create an SD card with the maps for the 93sv?

[fishin couillon]

To the OP: since both of your units have Pre-loaded maps, it will not share.....now if your 93 unit was a 92 with world base map then it would share the pre loaded maps from the 106.....

From the Garmin website:

Devices preloaded with charts, including Garmin Navionics+ charts, will not share their preloaded content to networked devices unless the other devices do not have preloaded maps. For example, ECHOMAP Plus 94sv will not share preloaded BlueChart maps with an ECHOMAP UHD 73cv, preloaded with LakeVu maps. However, it will share the preloaded map with an ECHOMAP Plus 72cv, which only has a base map

[187famous187]

Thanks guys. I have a second 106SV on the way for Livescope at the bow. The 93 UHD will just be for mapping/sonar. Not a huge deal they won’t share maps, I really just need the waypoints. Seems like an easy fix for Garmin tho