I am assuming it came loose after all the wireing, before I start digging where is the beeper usually. have never had one not work?
I am assuming it came loose after all the wireing, before I start digging where is the beeper usually. have never had one not work?
Ron Fears
Stroker/300XS
1E003823
no beep when key switch is activated by the way....
Ron Fears
Stroker/300XS
1E003823
Ron it's normally within about 3' of the ignition switch. Quarter-size buzzer with a purple wire and a tan w/blue stripe wire.
Note that if you have recently operated the trim, you will likely NOT receive a warning beep when key is turned on. This is because the PCM was awakened by the TRIM.
After sitting for 15+ minutes it should work again (normal test beep) as long as you don't hit trim.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 48 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Thanks Don, actually never had one fail, but the wiring has been messed with by two folks, I guess I am going to have to correct the mess over the winter, and man is it a mess, but in mean time I will fix alarm. Thanks again
Ron Fears
Stroker/300XS
1E003823
Reply With Quote
